NetSpa Järvi ice bath kit with 3 kW chiller

NetSpa Järvi ice bath kit with 3 kW electric chiller

The NetSpa Järvi SP-JRV300-CK3 is a complete set for setting up an ice bath with electric cooling. It combines the Järvi pool with a Drop-Stitch structure, a circulation pump with hoses and a 3 kW chiller unit. Its design pairs a stable, lightweight high-pressure inflatable structure with the components required to circulate and cool the water.

The pool can be used with ice cubes or connected to the chiller using the included D32 mm kit. This dual option allows the bath to be prepared according to the chosen cooling method. The thermal cover helps retain water temperature, while the handles and carry bag make it easier to move and store the pool when not in use.

Järvi pool with Drop-Stitch technology

Drop-Stitch construction enables high-pressure inflation, creating a rigid and stable basin during use. The pool includes a Drop-Stitch floor, inflation valve, safety buckles, handles, water inlet and outlet connections, and a drain plug. According to the model information, the pool inflates in under five minutes.

• Model NetSpa Järvi
• Reference SP-JRV300-CK3
• Structure Inflatable pool with Drop-Stitch technology
• External dimensions 1700 × 920 × 670 mm
• Cooling Compatible with ice cubes and an electric chiller
• Included chiller 3 kW
• Specified minimum temperature Down to 3 °C with C11 set to 3 °C
• Chiller connection D32 mm connection kit
• Specified warranty 2 years

Components included in the kit

The NetSpa Järvi with chiller is supplied in three packages containing the Järvi basin, water circulation system and cooling unit. The pack also includes the accessories required for inflation, connection and basic pool care.

• Pool Järvi Basin/UFC
• Circulation Circulation pump with hoses
• Cooling 3 kW chiller heat pump
• Inflation Inflation pump
• Filtration 1 antibacterial cartridge compatible with the chiller and circulation pump
• Thermal retention Thermal cover
• Hydraulic connection D32 mm connection kit
• Transport Carry bag
• Repair Repair kit

Water circuit connection

The hydraulic circuit is set up by connecting the lower outlet of the pool to the inlet of the circulation pump. The pump outlet is connected to the IN port on the chiller unit, while the OUT port on the chiller is connected to the upper inlet of the pool. PTFE tape may be used on threaded connections where needed to improve sealing.

Before filling, remove the two internal plugs and screw the filter onto the lower fitting. Once the water level is between the outlet and inlet of the basin, start the pump to purge air from the circuit; filling can then continue to the required level.

Chiller operation and installation requirements

To use cooling mode below 5 °C, set advanced parameter C11 on the chiller unit to 3 °C. Switch off the heat pump, press and hold the button for three seconds to access the parameters, select C11, change the value and confirm.

A format for wellness and training areas

With external dimensions of 1700 × 920 × 670 mm, the Järvi provides a compact basin for incorporating ice bath practice into wellness spaces, training areas or private installations. The combination of pool, circulation pump, chiller, cover and accessories provides a coordinated set for installation and use.